Introduction
The headphone volume Control Circuit is a simple and efficient way to adjust the volume of headphone amplifiers to the desired loudness levels. This circuit is designed to bridge this gap and provide a suitable loudness compensation for most listening volumes.
While built-in loudness controller circuits are present in modern amplifiers, many outdated or affordable amplifiers still need this feature. To address this issue, the Headphone Volume Control Circuit was designed as a simple and effective solution to provide a limited level of loudness compensation suitable for most listening volumes.
Hardware Required
You will require the following hardware for the Headphone Loudness Controller Circuit.
| S.no | Components | Value | QTY |
|---|---|---|---|
| 1 | Capacitor | 0.0033, 0.001, 0.033 | 1, 1, 2 |
| 2 | Resistor | 15k | 4 |
| 3 | Switch | – | 1 |
Circuit Diagram
Circuit Explanation
The headphone volume control circuit is made for mono amplifiers, but stereo amplifiers need two of them. It can be easily constructed on component strips or matrix boards and connected between the preamplifier and main amplifier. The circuit design allows for efficient and effective control of the headphone volume levels.
Connection of the Circuit with the Volume Control Circuit
In an integrated device, it is possible to connect the headphone loudness controller circuit in series with the slider terminal of the potentiometer in the volume control circuit. This connection ensures the circuit can be easily adjusted to provide the desired loudness levels.
Compromise Circuit for Loudness Control
It is important to note that the Headphone Volume Control Circuit is a compromise circuit. Ideally, a loudness control should be specifically designed to match the amplifier it is intended for. The amount of loudness compensation required will also depend on the volume control positioning.
Adjusting the Circuit for Specific Amplifiers
The level of loudness compensation can be adjusted for specific amplifiers by replacing the available volume control with an appropriately tapped potentiometer. However, this equipment is not readily available, so the Headphone Volume Control Circuit provides a limited compensation suitable for most listening volumes.
Minor Variations in Component Values for Circuit Adjustment
The circuit can be efficiently accommodated for most amplifiers and adjusted with minor variations in component values, if necessary. This ensures that the circuit can be used with a wide range of amplifiers and provides flexibility regarding loudness control.
Switch SW1 for Stereo Audio Functioning
For stereo audio functioning, switch SW1 can be a double-pole double-throw mode. This connection ensures the circuit can be used in stereo amplifiers to provide effective and efficient loudness control..
Final Words
Finally, the Headphone Volume Control Circuit is an effective way to adjust headphone volume levels for optimal listening experiences. It is a compromised circuit that can only compensate to a certain degree but can be changed to work with different amplifiers if needed. The circuit can be easily constructed and is suitable for most listening volumes.
booked up